Tektronix 2235 - VERTICAL

Preparation for U se-2235 ΑΝ /USM-488 Operators
If the original p ackaging is unfit for use or is n ot available,

3 . W ra p t he instrument with polyethylene sheeting or
repackage the instrument as follows :

equivalent to protect the outside
finish
a nd prevent entry of
p
acking
materials
into
the
instrument
.
1 . Obtain α corrugate d cardboar d s hipping carton h aving
insi de d imensions at least six inches greater than the instru-
ment dimensions and h aving α carton test strength of at
least 275 p ounds .
5 . Seal
the
carton
with
s
hipping
tape or
with
an
indus-
2 . If the instrument is to b e shipped to
α
Tektronix
Ser-

trial
stapler
.
vice Center for service or repair, attach α tag to the instru-
ment showing the following : owner of the instrument (with
address), the name of α person w ho can be contacted, com-

6 .
M ark t
he
address of the Tektronix Service Center and
plete instrument type and serial number, and α d escription

the return a dd ress on the carton in one or more prominent
of the service required .

locations .
4
. Cushion t he instrument on all sides by tightly p acking
d unnage or u rethane foam b etween t he carton and t he in-
strument,
allowing
three inches on each si de .