Tektronix 7834

Characteristic
TABLE 1-4 (CONT .)
Electrical Characteristics
RIGHT
Chopped Mode
Repetition Rate
VERT TRACE SEPARATION (B)
Deflection Factor
Difference Between
Horizontal Compartments
Fastest Calibrated Sweep Rate
Horizontal Display Mode
A
ALT
CHOP
Chopped Mode
Repetition Rate
Phase Shift Between
Vertical and Horizontal Deflection
Systems
With Option 2
(B
HORIZ Compartment Only)
Bandwidth (7D34 Horizontal Only with 10 Div Reference)
With Option 2(BHOR!ZCompartment Only)
AandBTRIGGER SOURCE
VERT MODE
LEFT VERT
RIGHTVERT
HORIZONTAL SYSTEM
TRIGGER SYSTEM
General Information-7834
Performance Requirement
Right vertical-unit
displayed .
1 MHz within 20% .
Positions "B" trace at least 4div above and below
"Y\^
trace, when 7834 operates in dual-sweep
mode .
Compatible with all 7000-series
plug-in units .
1ns/div .
Selected by fmnopanel HORIZONTAL MODE switch,
Aho,izonm! unit displayed .
Display alternates
between
A and
8horizonta! units .
Display chops between A and B horizontal
units .
B horizontal unit displayed .
200 kHz within 20% .
%" n,less from dctoatleast 35 kHz .
2 0 o,less from doto 1 MHz .
From dc to at least 1 MHz .
From dc to at least 1 MHz .
Selected by front-panel switches
.
From vertical unit se1ected by
VERTICAL MODE
switch ; except that in CHOP mode signals
are
added
algebraically .
From left vertical unit only .
From right vertical uni t only .