Tektronix 7834

REMOTE RESET INPUT
Signal Required
Minimum Pulse Width
Maximum Input
Voltage
Probe Power
Characteristics
REMOTE STORAGE GATE INPUT
Signal Required
Rise Time
Fall Time
Minimum Pulse Width
Input Resistance
Input Capacitance
REMOTE ERASE INPUT
Signal Required
Rise Time
Fall
Time
Input Resistance
Input Capacitance
Open Circuit Voltage
Maximum Input Voltage
Minimum
Pulse Width
TABLE 1-4 (CONT .)
Electrical Characteristics
Performance Requirement
Input for reset of single-sweep function of time-base
units installed in A and B HORIZ compartments
(compatible time-base units only) .
Switching from high level (+15 V to +10 V ; sink less
than 40 MA) to low level (+0 .5 V to -15 V ; sink less
than 10
mA),
in less than 1 ms, resets the sweep .
10 ps at 50% amplitude points .
+
or -15 V (dc plus peak ac) .
2 probe power connectors .
General Information-7834
Allows remote operation of high speed transfer . Low- to
high-level
transition enables High Speed Target to receive
information to
be
stored
.
High-to-low transition
initiates
transfer
from High Speed Target to Storage
Target
.
TTL voltage compatible .
1 ps or less . --
1 ps or less .
50 ns at 50% amplitude .
Greater than 15 kQ from
Approximately 100 pF
.
Approximately 0 V .
+ or ---15 V (dc plus peak ac)
1 ms or less .
10 /.is or less .
1 ms at 50% amplitude .
Greater than 27 kEZ .
Approximately
100 pF
.
-0 .6 to +5 V input .
Allows remote erasure of stored display . High-to-low
transition initiates an erase cycle when in a storage mode .
TTL voltage compatible .