Tektronix AFG3000 Series - Rear Panel

Operating Basics
2-2 AFG3000 Series Arbitrary/Function Generators Service Manual
 ArbExpress Software
 Context-sensitive Help system
Installation
Use the following information to safely install your instrument.
Operating Requirements
Environmental
Figure 2-1: Front size
1. Place the instrument on a cart or bench, observing clearance requirements:
 Sides: 50 mm (2 in)
 Rear: 50 mm (2 in)
2. Before operating, ensure that the ambient temperature is between 0 °C and
+50 °C (+32 °F and +122 °F).
Power Supply Requirements
Output
USB
Memory
USB
Memory
AFG 3102
1GS/s
100MHz
DUAL CHANNEL
ARBITRARY/FUNCTION GENERATOR
InputOutput Output
Channel
TriggerTrigger
View
Ch2 Ch1
Run ModeFunction
Sine
Leading/TrailingDuty/Width
Sweep Burst
Edit
Utility
Save RecallMore...
Arb
Pulse
Ramp
Square
Continuous Modulation
Default
Help
Offset/Low
Frequency/Period Amplitude/High
Phase Delay
156.3 mm
(6.16 in)
329.6 mm
(12.98 in)
CAUTION. To ensure proper cooling, keep both sides of the instrument clear of
obstructions.
Source Voltage and Frequency 100 V to 240 V, 47 Hz to 63 Hz
or 115 V, 360 Hz to 440 Hz
Power Consumption Less than 120 W