how to (continued)
check power-on self tests results 15
compensate TPP250, TPP0500B, TPP1000 probes 34
connect probes 15
connect to network 36
connect to PC using USB cable 17
download, install firmware 33
remote access the oscilloscope (from Web) 16
run signal path compensation (SPC) 34
set GPIB talk/listen address 17
set time 33
update firmware 33
use mouse with the UI 32
I
inactive channel buttons
21
Input connectors (front panel) 18
input signal level requirements 13
K
knob A 18
knob B 18
L
LAN port (rear panel) 19
LAN, connect to 36
Level knob 18
lock to bench or rack 14
LXI 16
M
manuals 10
Math button 18
Measure button 20
measurement badge 25
Menu bar 20
menu panels 29
menus 29
Mode button (front panel) 18
mouse touchscreen UI equivalents 32
multipurpose knobs 18
N
navigation buttons, badges 25
network, connect to 36
O
operating
altitude range 12
humidity range
12
temperature range 12
operating power requirements 12
P
panels, menu 29
pinching and handle rotate
11
position
knob 18
knob (horizontal)
18
power cord connector (rear panel) 19
power requirements 12
power standby mode 14
power-on test results 15
powering on or off 14
probe
compensation (TPP0500B, TPP1000) 34
compensation connectors 18
compensation TPP250 34
inputs 18
probes, connecting 15
proper handle rotate 11
R
rack mount kit information 16
rear panel
AFG Out 19
AUX Out 19
cable lock
19
connections 19
Ethernet port (RJ-45) 19
HDMI output 19
LAN port (RJ-45) 19
power cord 19
security cable lock 19
USB Device port 19
USB Host ports 19
record view, waveform 21
Ref button 18
remote access (e*Scope) 16
remote access (Web-based) 16
remove AC power from instrument 14
requirements
altitude 12
environment 12
humidity 12
power 12
signal inputs 13
temperature 12
Results bar 20
Results Table button 20
RF 23
RM3 rack mount 16
run signal path compensation 34
Run/Stop button 18
S
Save button 18
scale buttons, badge 25
Scale knob 18
|
To Next Page
Loading...
Need help?
General
