Installation
User Maintenance
Cleaning Your Instrument
Clean the exterior surfaces of the chassis with a dry lint-free cloth or a soft-bristle brush. If any dirt remains, use a cloth or
swab dipped in a 75% isopropyl alcohol solution. Use a swab to clean narrow spaces around controls and connectors. Do
not use abrasi
ve compounds on any part of the instrument because they might damage the instrument.
CAUTION. Avoid getting moisture inside the instrument during exterior cleaning; use j ust enough moisture to dampen the
cloth or swab. Do not wash the front-panel On/Standby switch. Cover the switch while washing the instrument. Use only
deionized o
r distilled water when cleaning. Use a 75% isopropyl alcohol solution as a cleanser and rinse with deionized
or distilled water. Do not use chemical cleaning agents; they might damage the chassis. Avoid chemicals that contain
benzene, toluene, xylene, acetone, or similar solvents.
CAUTION. T
o prevent damage to the flat panel display, do not use improper cleaning agents or methods. Avoid using
abrasive cleaners or commercial glass cleaners to clean the display surface. Avoid spraying liquids directly on the display
surface. Avoid scrubbing the display with excessive force.
Clean the
display surface by gently rubbing the display with a clean-room wipe. If the display is very dirty, moisten the wipe
with distilled water or a 75% isopropyl alcohol solution and gently rub the display surface. Avoid using excess force; this
might damage the display surface.
Upgradi
ng the Instrument Software
Software upgrades are available from Tektronix. They can either be downloaded from the Tektronix Web site or they can be
ordered from your local Tektronix representative. To add additional software options or features, y ou will need an option key
from Tektronix. When you receive the software from Tektronix, install it on your instrument. When prompted, enter the option
key, and then follow the online instructions to complete the upgrade.
Returning Your Instrument
If yo
u return your instrument to Tektronix:
Back
up any user software on the hard disk. You may need to reinstall the software after your instrument is returned.
When
repacking the instrument for s hipment, use the original packaging. If the packaging is unavailable or unfit for use,
contact your local Tektronix representative to obtain new packaging.
Seal the shipping carton with an industrial stapler or strapping tape.
RSA6100A Series & RSA5100A Series Q uick Start User Manual 15
To Next Page
Loading...
