Compliance Info
rmation
Compliance In
formation
This section lists the EMC (electromagnetic compliance), safety, and environment al standards with which the instrument
complies.
EMC Compliance
EC Declarati
on of Conformity – EMC
Meets intent of Directive 2004/108/EC for Electromagnetic Compatibility. Compliance was demonstrated to the following
specifications as listed in the Official Journal of the European Communities:
EN 61326-1, EN 61326-2-1. EMC requirements for electrical equipment for measurement, control, and laboratory use.
123
CISPR 11; IEC 61000-4-2: IEC 61000-4-3
4
; IEC 61000-4-4; IEC 61000-4-5; IEC 61000-4-6
4
; IEC 61000-4-11
5
EN 61000-
3-2, EN 61000-3-3.
European contact.
Tektronix UK, Ltd.
Western Peninsula
Western Road
Bracknell, RG12 1RF
1
This pro
duct is intended for use in nonresidential areas only. Use in residential areas may cause electromagnetic interference.
2
Emissions which exceed the levels required by this standard may occur when this equipment is connected to a test object.
3
For compliance with the EMC standards listed here, high quality shielded interface cables should be used.
4
With a 10 MHz 0.1 Vp-p sine wave signal applied to the A or B input channels, the instrument's frequency readout value can
typically vary up to ±1 Hz beyond the inherent base variance, when the instrument is subjected to the fields and signals as defined
in the IEC 61000-4-3 and IEC 61000-4-6 tests.
5
Performance Criterion C applied at the 70%/25 cycle Voltage-Dip and the 0%/250 cycle Voltage-Interruption test levels
(IEC 61000-4-11).
Australia / New Zealand Dec laration of Conformity – EMC
Compl
ies with the EMC provision of the Radiocommunications Act per the following standard, in accordance with ACMA:
CISPR
11
Australia / New Zealand contact.
Baker & McKenzie
Level 27, AMP Centre
50 Bridge Street
Sydney NSW 2000, Australia
vi FCA3000, FCA3100, and MCA3000 Series Q uick Start User Manual
To Next Page
Loading...
