Application examples
This section presents a series of application examples. These simplified examples
highlight the features of the oscilloscope and give you ideas for using it to solve
your own test problems.
■
Taking simple measurements
■
Using Autoset
■
Using the Measure Menu to take automatic measurements
■
Measuring two signals and calculating gain
■
Using Autorange to examine a series of test points
■
Taking cursor measurements
■
Measuring ring frequency and ring amplitude
■
Measuring pulse width
■
Measuring rise time
■
Analyzing signal detail
■
Looking at a noisy signal
■
Using the average function to separate a signal from noise
■
Capturing a single-shot signal
■
Optimizing the acquisition
■
Measuring propagation delay
■
Triggering on a pulse width
■
Triggering on a video signal
■
Triggering on video fields and video lines
■
Using the window function to see waveform details
■
Analyzing a differential communication signal using Math functions
■
Viewing impedance changes in a network using XY mode and persistence
■
Data logging (non-EDU models only)
■
Limit testing (non-EDU models only)
TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual 29
To Next Page
