Removal and Installation Procedures
6-18
TDS 420A, TDS 430A & TDS 460A Service Manual
Table 6- 6: Access Instructions for Modules in Figure 6- 3 ( Cont.)
Procedure Including Module to be Removed Access Instructions
Page
No
12 Back-Up Batteries 6--53 1 Do the procedure listed at left to remove the module.
13 A04 Acquisition Assembly 6--69 1DoA08 Jumper Board Assembly, D1 Bus, and Board Supports
(see page 6--44). Do not remove the board supports.
2 Do the procedure listed at left to remove the module.
To Next Page
Loading...
