Getting Started
Functional Check
Perform this qu ick functional check to verify that your oscilloscope is
operating correctly.
1. Connect the oscilloscope power
cable. (See page 10.)
2. Power on the oscilloscope.
Wait for the confirma tion that all self
tests have passed.
Probe Comp
3. Connect the oscilloscope probe to
channel 1. Attach the prob e tip and
referenceleadtotheProbe Comp
connectors.
4. Push the Autoset button. You
should see a square wave in the
display (approximately 5 V at
1kHz).
2 TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
