Getting Started
5. Horizontal Position. Adjusts the trigger point location relative
to the acquired waveforms. Push the Coarse button to make
adjustments quickly.
6. Trigger Level. Adjusts the trigger level.
7. Run/Stop. Stops and restarts acquisition.
8. Single Seq. Sets acquisition, display, and trigger parameters for a
single-shot (single-sequence) acquisition.
9. Set To 50% . Sets the trigger level to the midpoint of the waveform.
10. Autoset. Automatically sets the vertical, horizon tal, and trig ger
controls for a usable display.
11. Force Trig. Forces an im m ediate trigger event.
12. Wavefo rm I ntensity. Co ntrols waveform intensit y.
13. B Trig. Activates the B trigger. Changes the Trigger menu to set
the B -t rigger param eters.
14. Delay. Enables delayed acquisition relative to the trigger event.
Use horizontal Position to set the amount of del ay.
15. Horizontal Scale. Adjusts the horizontal scale factor.
16. Horizontal Zoom. Splits the screen and magnifies the current
acquisition horizontally.
17. Waveform Off. Removes selected waveform from the display.
18. Vertical Scale. A djusts selected waveform vertical scale factor.
19. 1, 2, (3, 4,) Math. D isplay s a wa veform and chooses the selected
waveform. Ref shows the reference w aveform men u.
22 TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
Need help?
General
