Removal and Installation Procedures
TDS7104 & TDS7054 Service Manual
6-- 43
d. Grasp the Riser board and pull it straight out to disconnect J510 edge
card connector from the NLX board. Remove the Riser Adapter board
from the NLX board assembly.
e. Remove the four T-15 Torx screws that secure NLX board to the NLX
support bracket.
f. Remove the six 3/16 nut posts that secure the three connectors to the rear
of the support bracket. Then remove the NLX board from the support
bracket.
g. Remove the N LX board from the support bracket.
5. Reinstallation: Do in reverse steps 3 and 4 to reinstall the NLX board.
To Next Page
Loading...
