To Next Page

To Previous Page

Table of Contents

TDS7104 & TDS7054 Service Manual

List of Figures

Figure 2--1: Locations of peripheral connectors on rear panel 2--3.....

Figure 2--2: Line fuse and power cord connector locations,

rear panel 2--4.............................................

Figure 2 --3: On/Standby switch location 2--5.......................

Figure 4 --1: Toolbar and menu bar 4--3...........................

Figure 4--2: Universal test hookup for functional

tests -- CH 1 shown 4--7.....................................

Figure 4 --3: Channel button location 4--8..........................

Figure 4--4: Setup for time base test 4--10...........................

Figure 4--5: Setup for trigger test 4--12.............................

Figure 4--6: Setup for the file system test 4--14.......................

Figure 4--7: Initial setup 4--20....................................

Figure 4--8: Setup to characterize signal source outputs 4--23..........

Figure 4--9: Setup to check delay between channels 4--24..............

Figure 4--10: Setup to check delta time accuracy 4--24................

Figure 4 --11: Setup to check probe compensation output 4--25.........

Figure 4--12: Setup to check analog signal output 4--25...............

Figure 4--13: Setup to check auxiliary output 4--25...................

Figure 4--14: Initial test hookup 4--36..............................

Figure 4--15: Measurement of DC accuracy at maximum

offset and position 4--38......................................

Figure 4--16: Initial test hookup 4--39..............................

Figure 4--17: Measurement of DC gain accuracy 4--42................

Figure 4--18: Initial test hookup 4--44..............................

Figure 4--19: Optional initial test hookup 4--44......................

Figure 4--20: Measurement of analog bandwidth 4--47................

Figure 4--21: Initial test hookup 4--49..............................

Figure 4--22: Measurement of channel delay 4--51...................

Figure 4--23: Initial test hookup 4--53..............................

Figure 4--24: Initial test hookup 4--57..............................

Figure 4--25: Measurement of accuracy -- long-term and

delay time 4--59.............................................

Figure 4--26: Initial test hookup for external reference 4--60...........

Figure 4 --27: Final test hookup for external reference input 4--61.......

Figure 4--28: Delta time accuracy test hookup 4--62..................

Tektronix TDS7104 Service Manual

Other manuals for Tektronix TDS7104