Audio Performance Verification Procedures
Control or Setting
Value
Data
ALL ZERO
Audio Bits 24
Unbal Vpp 1.0000 V
Bal Vpp 4.0000 V
Max Volt
1.0000 FS
Ref Freq
1000.0 Hz
Ref Volt 1.0000 FS
PROTOCOL STATIC
Ch Stat. L FILE + CRC
Filenam
e
R&S_AES3.PGC
Ch Stat. R EQUAL L
AUX GEN OFF
FUNCTION - SINE
Frq Offset OFF
DC Offset OFF
Dith
er
OFF
Equ
alizer
OFF
SWEEP CTRL OFF
FREQUENCY
10
0.0 Hz
VOLTAGE 0.5000 FS
10. Connect the Output 1 XLR of the breakout cable to the analyzer balanced
(BAL) analog input.
11. Check for an indication of 18 dBu ±0.5dB on the analog analyzer and record
the result in the test record.
12. Change the digital audio generator FREQUENCY to 1000 Hz.
13. Check for an indication of 18 dBu ±0.5dB on the analog analyzer and record
the result in the test record.
14. Change the digital audio generator FREQUENCY to 19000 Hz.
15. Check for an indication of 18 dBu ±0.5dB on the analog analyzer and record
the result in the test record.
16. Repeat steps 8 through 15 for each of the other Output XLR connectors.
17. Disconnect the test setup.
Waveform Monitors Specifications and P erformance Verification 133
To Next Page
Loading...
