Digibar S User
User Manual
Page 4 of 14
July 11, 2010
1 INTRODUCTION
The Digibar S was designed to measure the speed of sound in water as well as pressure and temperature. The
Digibar S uses a 2 MHz transducer and time-of-flight circuitry sounding across a know distance to measure the
sound velocity directly. Measurements from the Digibar S are stored internally in non volatile memory which is
then downloaded using a USB port on a computer.
1.1 Purpose
The purpose of this document is to explain the features and operation of the Digibar S sound velocity probe.
1.2 Scope
The scope and content of this document is focused on providing useful information to the end-user concerning
both installation and operation of the instrument.
To Next Page
