Digibar S User
User Manual
Page 7 of 14
July 11, 2010
LED blinking 1 times/second – The Digibar S is ready to be deployed in the water. Once in the water the
LED will go off.
LED blinking 4 times/second – The Digibar S battery voltage is at a critical voltage and should be
charged. Connect to the USB charger to charge quickly.
LED blinking irregularly - This indicates the Digibar S memory is full and needs to be cleared before
starting a cast. The Digibar S will not overwrite previously stored cast data.
2.4.5 Download/Charging cable
This cable connects the Digibar S to a computer’s USB port. This allows the Digibar S to communicate with a
computer as well as charge the probe’s batteries. To charge the batteries quicker plug the USB end of the cable
to the supplied USB charger.
2.4.6 USB Charger
A USB wall charger is supplied with the Digibar S to charge the batteries at a faster rate than is possible with a
computer’s USB port. The Digibar S should not be left plugged into the USB wall charger for over 24 hours. The
wall charger will work from 90 VAC to 240 VAC.
2.4.7 Silicone Capsules
Silicone capsules are provided to lubricate the pins on the Digibar S probe.
To Next Page
