Televes H30FLEX Sky - MDU Measurement Functions; MDU Features, Alignment Check, and Dish Check

EN
13
When the scan is nished, the result of the scan is
shown in the screen:
If one or more channels fail, it is considered that
the dish check fails.
3.- MDU
All the MDU (Multiple Dwelling Units) features are
collected in this menu. Both for installation and
service operations.
There are two options, depending on the type of
MDU: Sky Q (DCSS or dSCR) and Classic (for classic
STBs).
All the features work in the same way: the installer
must follow several steps indicated in the screen.
These steps are explained below, but they may
appear in a dierent order according to the type of
MDU and the type of operation (install or service):
3.1.- Alignment Check
This feature checks that the dish is propertly
aligned.
Below is a capture of the Alignment Check window
with a brief explanation of its features.
Channel and
Frequency
Use to hange
Long press OK to
go to Channel Info
Bar graph of power
measurement
Color according to
checkmarks
Power and LKM
measurements
of the selected
channel with
pass/fail indicator
Result of
the scan
The performance measurement is the quotient
between the current LKM value and the maximum
one. When the performance indicator is green, the
dish is aligned.
3.2.- Dish Check
This feature makes a scan in 6 channels of the plan
to check the LNB and the good reception of the
signal.
Below is a capture of the Dish Check window with
a brief explanation of its features.
Bar graph of LKM
measurement
Color according to
checkmarks
Press OK to conrm
dish allignment
and go to the next step
(see section 4.3.- Dish
Check)
Bar graph of power
measurement
Color according to
performance
List of
measurements
Performance
measure has
pass/fail indicator
Channel
and
Frequency
Channel and
Frequency
Use to hange
Long press OK to
go to Channel Info
Bar graph of power
measurement
Color according to
checkmarks
Power and LKM
measurements
of the selected
channel with
pass/fail indicator