32
Using Voice-Activated Microphone (VOX)
If you use VOX, you do not have to insure that the microphone key is turned on whenever you want to talk.
To activate VOX, do the following:
1. Verify the headset and panel mic key are off.
2. If you are using a headset, tap the headset key twice to turn on headset vox.
OR
If you are using a panel microphone, tap the panel mic key twice to turn on panel mic vox.
Whichever key you tap lights orange when the microphone is off and blinks or turns green when the microphone turns
on.
NOTE: The VOX level may require adjustment, see Figure , “Voice-Activated Microphone Setup,” on page 29.
Incoming Call Beep On/Off
Normally, incoming calls are indicated by red-flashing call keys.
To turn the incoming call beep on and off, do the following:
1. Verify call beep has been activated via internal switches.
2. Press and hold the Mic Kill key for about two (2) seconds, then release it.
The Mic Kill key lights green to indicate the intercom station is in programming mode.
3. Tap either call key on the US-2002 to turn the beep feature on or off.
4. Tap the Mic Kill key to return to normal operation.
To Next Page
Loading...
