BlueMod+S50 Hardware User Guide
1VV0301505 Rev. 1 Page 40 of 53 2018-03-02
9. COMPLIANCES
The BlueMod+S50/AI and BlueMod+S50/AP have been tested to fully comply with the
appropriate EU, FCC and IC directives.
CE testing is intended for end products only. Therefore, CE testing is not mandatory for a
Bluetooth module sold to an OEM end product. However, Telit provides CE tested modules
for customers in order to ease CE compliance assessment of end products and to minimize
test effort.
OEM end product compliance assessment has to be done for every end product by the
OEM’s certification manager. It should be noted that compliance assessment doesn’t
necessarily mean re-testing in the test lab. Telt test reports are available on request and
can be used to drastically reduce the test plan and compliance testing costs.
All certifications and declarations, except RoHS and ReacH, are only
valid for the BlueMod+S50 running with Telit FW. If the FLASH is
erased and a customer specific FW is loaded all certifications have to
be re-evaluated or renewed.
All measurements and certifications have been do
BlueMod+S50/AI with internal ceramic antenna and with a specific
external antenna for the BlueMod+S50/AP, which offers the RF signal
standalone test board trace design and uses exactly the same antenna
given in chapter
7.5 OEM Layout and Antenna Selection in Respect to
RED/FCC/IC Certification.
If this trace design is not the same or the this specific antenna is not
used the following actions should be done.
• RED Re-assess RED compliance
• FCC Class II Permissive Change
• IC Class II Permissive Change
Declaration of Conformity CE
The BlueMod+S50/AI and the BlueMod+S50/AP do fully comply with the essential
requirements of the following EU directives:
• RED 2014/53/EU
• RoHS 2011/65/EC
The actual version of EU Declaration of Conformity (EU DoC) can be downloaded from
https://www.telit.com/RED
To Next Page
Loading...
