BlueMod+S50 Hardware User Guide
1VV0301505 Rev. 1 Page 42 of 53 2018-03-02
9.2.5. FCC RF-exposure Statement
The BlueMod+S50/AI and BlueMod+S50/AP, if used with the antenna described in chapter
7.5 OEM Layout and Antenna Selection in Respect to RED/FCC/IC Certification, do comply
with the FCC/IC RF radiation exposure limits set forth for an uncontrolled environment.
According to table 1B of 47 CFR 1.11310 “Limits for Maximum Permissible Exposure
(MPE), Limits for General Population / Uncontrolled Exposure” the power densitity at 20 cm
distance to the human body is well below the limit of 1mW/cm2.
For the BlueMod+S50/AI the distance to the human body may be 0cm.
The same applies for the BlueMod+S50/AP if the specific antenna
stated in 7.5
RED/FCC/IC Certification is used. But if a different antenna is used,
MPE has to be re-evaluated.
9.2.6. FCC Labeling Requirements for the End Product
Any End Product integrating the BlueMod+S50/AI or BlueMod+S50/AP must be labeled
with at least the following information:
This device contains transmitter with
FCC ID: RFR-S50
IC: 4957A-S50
To Next Page
Loading...
