Telit Wireless Solutions BlueMod+S50/AI - Page 44

BlueMod+S50 Hardware User Guide
1VV0301505 Rev. 1 Page 44 of 53 2018-03-02
9.3.3. IC Caution
WARNING:
Changes or modifications made to this equipment not expressly
approved by Telit may v
oid the IC authorization to operate this
equipment.
9.3.4. IC RF-exposure Statement
This equipment is portable device. According to RSS-102 Issue 5 §2.5.1 Exemption Limits
for Routine Evaluation – SAR Evaluation Table 1, the allowed distances to the human body
for products implementing the BlueMod+S50/AI or BlueMod+S50/AP can be calculated as
follows. If the intended use of the end product asks for smaller distances a SAR evaluation
has to be repeated with the end product.
• Max. RF output power is +3.5dBm
• Antenna peak Gain is +3dBi
• Resulting max. RF output power is +6.5dBm = 4.5mW < 7mW
• Table 1 of RSS-102 Issue 5 §2.5.1 shows that for 2450MHz the distance at 7mW
should be ≥ 1cm
If the BlueMod+S50/AP is used with a different antenna as stated in 7.5
OEM Layout and
Antenna Selection in Respect to RED/FCC/IC Certification
, SAR evaluation has to be re-newed.
9.3.5. IC Labeling Requirements for the End Product
Any end product integrating the BlueMod+S50/AI or BlueMod+S50/AP must be labeled with
at least the following information:
This device contains transmitter with
FCC ID: RFR-S50
IC-ID: 4957A-S50
9.3.6. IC Label Information BlueMod+S50
The BlueMod+S50/AI and the BlueMod+S50/AP show the IC-ID on the product label.
Model: BlueMod+S50
The IC-ID is: 4957A-S50