This document is the property of Telma. It cannot be copied, forwarded, or given to any party without prior agreement form TELMA. Any infringement will immediately involve legal action.
TELMA S.A., 28 rue Paul Painlevé, F-95310 Saint-Ouen l’Aumône - www.telma.com 5 / 18 OC441691
4. PARTS TO BE REPLACED SYSTEMATICALLY
When removed, the following parts need to be replaced by the new ones which are supplied
with the spare hub assembly:
- Shaft end screws, washers, air gap adjusting shims and lock tabs
- Screws used to secure hub
- Screws used to secure pole shoes plate
- Dust protection washers
5. NOTES
Some parts handled during the maintenance operations are covered with a special product
against corrosion. Take precautions when handling to prevent damage to these protections.
For ease and given the diversity of installations on vehicles, this procedure has been done with the
retarder removed from the vehicle and its accessories (retarder brackets) removed from the
retarder.
To remove the retarder brackets, please refer to the appropriate procedures.
The different pictures on this procedure are generic views and are not contractual.
To Next Page
Loading...