·
To enter any of the per-line programming commands for Lines 2
through 4, you must first select the line using commands 02, 03, or 04.
While any of these lines is selected, you can also enter any
systemwide programming command.
Command Format
For each feature to be programmed, a command is entered at the telephone
keypad. All commands start with
* and end with #. The # is also used to
separate data fields if the command has more than one field. That is:
*<two digit command code>#<data field>#
-or-
in the case of commands with multiple data fields:
*<two digit command code>#<data field>#<data field>#
For example, to program 123 as the audio port access number, enter:
*06#123#
To program the audio port to immediate access, multiple user, and disconnect
at end of message, enter:
*05#1#1#1#
Commands having multiple data fields can be abbreviated if the latter fields
are to be set to zero. For example,
*05#2## sets the audio access port to dial
access, single user, disconnect at off-hook.
If the TLS-4A accepts the code, you will hear a confirmation tone of three short
beeps. If the code is rejected, you will hear the error tone. If you hear error
tone, verify that the code and values you are trying to enter are valid, and try
again.
To correct command code mistakes:
If you made an error in entering the command code and have not yet entered a
#, key
* to cancel the command. When you hear three beeps, enter the
command again.
To correct data field mistakes:
If you made an error in entering within a data field, (that is, after one or more
#s have been entered prior to the final #, key
* to erase the current field back
to, but not including, the #, or
** to cancel the entire command. When you
hear three beeps, re-enter the command.
Reference Manual Chapter 6: Programming
40-400-00033, Rev. C
Page 23
To Next Page
Loading...
