Need help?Do you have a question about the Teltone TLS-4A and is the answer not in the manual?
Precautions for discharging electrostatic buildup before operating the equipment.
Lists programmable operations and physical characteristics of the TLS-4A.
Explains LED indicator states and blinking patterns for the TLS-4A.
Assigning two numbers to each line for varied ring cadences or hunt groups.
Configuring the audio port for access as a monitor or for communication.
Programmable ring cycle timing for a second number on each line.
Simulating simultaneous ringing of multiple phones with a single pilot number.
How the TLS-4A responds to invalid dialed numbers.
Explains Standard, Hot Line, and Silent modes for off-hook operation.
Explains how Hunt Mode simulates trunk groups/telethons for groups of lines.
Step-by-step guide to demonstrate the TLS-4A's functionality.
Procedure to reset the TLS-4A to its original factory operating conditions.
Assumes default settings and guides through testing procedures for key systems/PBX lines.
Steps to establish a multi-party conference call.
Procedure to transfer an established call to a third party.
Procedure to re-enable flash detection if it was disabled.
Instructions for generating and playing messages via the audio port.
Steps to record a message onto a tape recorder for the audio port.
Steps to record a message directly from a telephone via the audio port.
Instructions to play recorded messages through the audio port.
How to cancel immediate access to the audio port.
Explains the method for automatically turning off a tape recorder at message end.
Connects TLS-4A lines to PBX/key system trunks for testing.
Tests the manual continuous ring function using Line 1.
Tests line wiring and basic connectivity using tone or rotary phones.
Tests equipment expecting specific ring cadences.
Verifies tone pad frequencies and audio signal reception.
Checks the operation of the telephone mouthpiece.
Tests device response to various call progress tones.
Lists specific numbers to test responses to dial tone, busy tone, etc.
Setting up an indefinitely open, silent line for test purposes.
Details two methods for entering programming mode.
Explains the syntax for entering programming commands.
Table to look up commands by number, name, or page.
Sets audio port access mode (monitor, immediate, dial).
Sets the dial access number for the audio port.
Selects the type of ringing frequency for the line.
Programs the primary telephone number for each line.
Programs an alternate telephone number for each line.
Sets hot line numbers or revert to dial tone numbers.
Sets ring cadence for the second phone number.
Determines response (busy/reorder) when line is busy.
Determines response to invalid dialed numbers.
Configures ringdown, hot line, or silent modes for off-hook.
Permits or denies access to the audio port.
Determines if the TLS-4A recognizes a 'flash' signal.
Sets how hunt groups respond when a shared number is dialed.
Determines if a line gets a forced disconnect when the other line goes on-hook.
Programs numbers to hear dial tone, busy tone, reorder, ringback, or silence.
Copies programming from one line to another.
Finds the current setting for any programmable feature.
Details the product warranty period and terms.
General troubleshooting steps, starting with checking the fuse.
Instructions on how to obtain an RMA and return a defective unit.
Contact information for technical assistance and support.
General| Brand | Teltone |
|---|---|
| Model | TLS-4A |
| Category | Telephone System |
| Language | English |
To Next Page
