Systemwide Commands
**99##: Programming Mode
Use this command to enter programming mode from Line 1 with all other
lines on-hook.
00: Reset to Defaults
This command resets the factory default operating conditions, either for the
entire unit, or for one or more lines. Each command must be entered twice, as
shown below.
·
To restore all defaults, enter:
*00#0#*00#0#
·
To restore defaults for Line 1, enter:
*00#1#*00#1#
· To restore defaults for Line 2, enter:
*00#2#*00#2#
· To restore defaults for Line 3, enter:
*00#3#*00#3#
· To restore defaults for Line 4, enter:
*00#4#*00#4#
01 - 04: Select Line 1, 2, 3, or 4 for Programming
This command selects Line 1, 2, 3, or 4 so you can set any of the
per-line-programmable features (commands 11-52, and 90, 99) for Line 1.
Note:
Use this command only if you have previously selected another line for
programming. On the first access to programming mode, Line 1 is
automatically selected.
*01#
The Line 1 light begins blinking. When you have finished programming Line
1, you can either (1) select another line, or (2) hang up to exit programming
mode.
To select Line 2, enter:
*02#
Telephone Line Simulator 4A
Page 28
To Next Page
Loading...