Command
Number
Command Description Page
35 Hunt Mode Use this command to set how a “hunt group” or group of
phones sharing a single telephone number, responds when
the shared telephone number is dialed.
The default is ring all or “hunt mode”.
37
36 Attenuation This command can be turned on or off. If it is turned on,
the TLS will lower the volume (i.e., loudness) of a call.
The default is disabled or no attenuation.
38
38 Forced Disconnect Use this command to determine whether a line gets a
forced disconnect when the other line hangs up.
The default is forced disconnect on.
38
60 Dialtone Number Use this command to program a number that will respond
with continuous dial tone until you hang up.
The default number is 83781 (TEST1).
39
61 Busy Tone Number Use this command to program a number that will respond
with busy tone until you hang up.
The default number is 83782 (TEST2).
39
62 Reorder Tone
Number
Use this command to program a number that will respond
with reorder tone until you hang up.
The default number is 83783 (TEST3).
39
63 Ringback Tone
Number
Use this command to program a number that will respond
with ringback tone until you hang up.
The default number is 83784 (TEST4).
39
64 Silence Number Use this command to program a number that will respond
with silence until you hang up.
The default number is 83785 (TEST5).
39
90 Clone Line X Use this command to copy the programming from one line
to the line you are calling from. For example, if you enter
*90#1# from Line 2, the programming from Line 1 is
copied to Line 2.
There is no default for this command.
40
99 Programming Query Use this command to find out how a particular command is
set. This command does not work with commands 00-04.
There is no default for this command.
40
Reference Manual Chapter 6: Programming
40-400-00033, Rev. C
Page 27
To Next Page
Loading...
