·
To cause the TLS-4A to ring the next available line that has this number; that
is, the next higher line number after the last one used (if Line 2 was the last
line rung, Line 3 will be rung), enter:
*35#3#
36: Attenuation
This command turns down the volume of sound transmitted on this line.
When there are two active calls, the TLS-4A will apply attenuation to both
calls; however, attenuation will not be doubled if one attenuated line calls
another.
·
To disable attenuation (default), enter:
*36#0#
·
To enable attenuation, enter:
*36#1#
38: Forced Disconnect
This feature determines whether this line gets a forced disconnect when the
other line goes back on-hook.
· To enable (default) forced disconnect, enter:
*38#1#
Note:
The TLS-4A cannot ring one line while sending a forced disconnect to
another. If these actions are attempted simultaneously, either the ringing
or the forced disconnect will be delayed until the other is finished.
·
To disable forced disconnect, enter:
*38#0#
39: Tone Following Disconnect
This command sets the tone that will be heard after a forced disconnect or, if
forced disconnect is disabled, the tone will be heard after the delay before
disconnect.
If x=4, the caller will be connected to the audio port and will hear any
announcement you have recorded.
*39#x#
where: x=0, dialtone (default)
x=1, busy
x=2, reorder
Telephone Line Simulator 4A
Page 38
To Next Page
Loading...
