x=3, silence
x=4, audio port
60: Dial Tone Number
This command programs a number that you can dial to hear continuous
dialtone. This is used to test or demonstrate how a device responds to
continuous dialtone.
*60#x#
where: x = 0-16 digits
83781 or “TEST1” (default)
61: Busy Tone Number
This command programs a number that you can dial to hear busy tone. It is
used to test or demonstrate how a device responds to busy tone.
*61#x#
where: x = 0 -16 digits
83782 “TEST2” (default)
62: Reorder Tone Number
This command programs a number that you can dial to hear reorder tone. It is
used to test or demonstrate how a device responds to reorder tone.
*62#x#
where: x = 0 - 16 digits
83783 or “TEST3” (default)
63: Ringback Tone Number
This command programs a number that you can dial to hear ringback tone. It
is used to test or demonstrate how a device responds to ringback tone.
*63#x#
where: x = 0 - 16 digits
83784 or “TEST4”
64: Silence Number
This command programs a number you can dial to hear silence. It is used to
test or to demonstrate how a device responds to silence on the line.
*64#x#
where: x = 0 - 16 digits
83785 or “TEST5”
Reference Manual Chapter 6: Programming
40-400-00033, Rev. C
Page 39
To Next Page
Loading...
