90: Clone Line X
This command copies the features programmed for another line to this line.
Note:
When a line is cloned, the line’s telephone number are not cloned.
·
To copy Line 1 programming to this line, enter:
*90#1#
·
To copy Line 2 programming to this line, enter:
*90#2#
·
To copy Line 3 programming to this line, enter:
*90#3#
· To copy Line 4 programming to this line, enter:
*90#4#
99: Programming Query
This command is used to find out the current setting for any programmable
feature. The TLS-4A will give a voice response to query commands.
· Enter the query command as:
*99#xx#
where: xx is any command code.
The following commands give special results:
*99#99#, A voice speaks digits 0 through 9.
*99#98#, A voice speaks the firmware version number.
*99#00#, 8 seconds of 1 kHz tone are returned.
Codes 01 through 04 are not applicable query commands.
Telephone Line Simulator 4A
Page 40
To Next Page
Loading...
