08: Confirmation and Error Tones
This command determines whether or not the TLS-4A will return confirmation
and error tones at the end of each programming command.
·
To disable the function so that no tones will be given
.
*08#0#
·
To enable the function so that tones will be given (default), enter:
*08#1#
09: Device Disconnect Timer
This command sets the time that the TLS-4A will wait before sending a
disconnect to a line remaining off-hook at the end of a conversation after other
line(s) are on-hook. (Default is 20 or 2 seconds.)
Please refer to command 38, Forced Disconnect on page 38.
*09#x#
where: x is a number between 10-200 representing tenths of seconds (For
example, x=199=19.9 seconds)
Reference Manual Chapter 6: Programming
40-400-00033, Rev. C
Page 31
To Next Page
Loading...
