23: Ring Cadence, Second Phone Number
This command sets second phone numbers which can be programmed to ring
a single, double, or triple ring, with on and off times as specified in this
command:
*23#a#b#c#d#e#f#
where: a is the “on” time of the first ring, b is the “off” time of the first
ring, c is the on time of the second ring, and so on.
a, c, and e can be any numbers from 0 through 30 representing
tenths of seconds (30 = 3.0 seconds).
b, d, and f can be any numbers from 0 through 63 representing
tenths of seconds (63 = 6.3 seconds).
Default: 1 second on, 1 second off, 1 second on, 3 seconds off.
·
To disable ringing, enter:
*23# #
· To set the first on time and first off time to 30 and set the rest to 0 for
continuous 3 second off/3 second off ringing, enter:
*23#30# #
· To set the on time to 30 and the first off time to 0 (i.e., continuous ringing),
enter:
*23#30#0# #
30: Response to Busy
Determines the response that will be given to callers on other lines if this line is
busy when dialed.
·
To respond to callers with a busy signal (default), enter:
*30#0#
·
To respond to callers with a reorder tone, enter:
*30#1#
31: Response to Invalid Number
This command determines the response that will be given to callers on this line
who dial a number that does not match any of phone numbers programmed
for the other lines.
Telephone Line Simulator 4A
Page 34
To Next Page
Loading...
