Section 3 - Step-By-Step Assembly 21
Temp-Cast 2000 Installation Manual
STEP 11:
These 2 parts, #22 & 23, form the floor of the secondary combustion chamber. They are not
keyed and are simply mortared in position with a thin bead of refractory mortar, around the
edges and between the 2 parts. (If this installation includes a Bake Oven, these parts and
subsequent courses are detailed on page 26.)
Tap firmly into place with the rubber mallet, to create as thin a joint as possible.
Weights
#22 & 23 - 40 lbs
To Next Page
