TEMPMASTER
78
FORM TPM3-EG1 (518)
EXECUTION
Installation
General: Installing contractor shall install unit(s), including components and controls re-
quired for operation, in accordance with unit manufacturer’s written instructions and rec-
ommendations. Units shall be installed as specified.
1. Unit(s) specied shall include a protective covering membrane for such equipment
being shipped by truck, rail, or ship. The membrane is fully formed around the equip-
ment exterior. The membrane covers the entire top, side, and end panel surface as
to protect the product effectively during shipping and storage, including long term
storage. Storing on the job site shall no longer require the unit(s) to be covered with
a tarp as long as the covering membrane has not been removed.
2. All size or shape equipment including electrical components, especially those not
built with weatherproof enclosures, VFDs, and end devices shall be effectively cov-
ered for protection against rain, snow, wind, dirt, sun fading, road salt/chemicals,
rust, and corrosion during shipping cycle. Equipment shall remain clean and dry.
3. Manufacturers of units not having a protective membrane fully formed around the
equipment exterior, covering the entire top, side, and end panel surface area shall be
required to ship equipment covered with a tarp, in crating, or in a closed truck as is
necessary to ensure product protection from road salt/chemicals damage, moisture,
and dirt inltration. Arrangements for long term storage at the job site shall be required.
Location: Locate the single package unit as indicated on drawings, including cleaning
and service maintenance clearance per manufacturer instructions. Adjust and level the
single package unit on support structure.
INSPECTION AND START-UP SUPERVISION
A factory-trained service representative of the manufacturer shall supervise the unit start-
up and application specific calibration of control components.
To Next Page
Loading...