How to troubleshoot a Temspec VUD 1200 Fan that is not running?
If the Temspec Fan is not running, begin by verifying power to the motor. Then, make sure all wiring connections are correct and secure. Check that the controller sends the correct signal and that the fan relay is energizing properly. If applicable, check if the speed board is working. Finally, to ensure the motor hasn't failed, swap it with a working unit.
What to do if the Temspec Outdoor Fan is not supplying enough air?
If the Temspec Outdoor Fan isn't supplying enough air, you can try the following: * Adjust the speed control (VGB). * Check and adjust the stopper bracket position on the outdoor air damper if needed (VGB Series). * Balance the fan. * Adjust speed taps (VER). * Ensure the unit has a proper seal to the outside Louver. * Adjust the outdoor air damper minimum position.
Why is the electric heat on my Temspec not working?
If the Temspec Electric heat is not working, first, ensure all wiring connections are correct and secure. Next, verify that the heater relay is functioning and that proper voltage is reaching the heater. Also, ensure the controller is sending the correct signal. Finally, check that the manual high-temperature switch is not tripped.
What causes a Temspec Damper not to work?
If the Temspec Damper is not working, make sure all wiring connections are correct and secure. Also, ensure the actuator is getting proper voltage and that the controller is sending the proper control signal.
How to troubleshoot a Temspec Water valve that is not working?
To troubleshoot a Temspec Water valve that is not working, make sure all wiring connections are correct and secure. Check that the actuator is getting proper voltage and that the controller is sending the proper control signal. Also, check that the overflow switch is not tripped.
To Next Page
General