Click “Save” to complete the setup wizard. The Router
will record the settings you made. To activate the
settings, it is recommended to select “Reboot the
Router” from “System Tool” of the left menu. It is
rebooting now, please wait for a few minutes and DO
NOT power off it. Please use the new parameters to
run the Router.
After rebooting the Router, you can click the “Running
Status” on the right menu to check the connection
between the Router and ISP device. If the status
information of the WAN port appears as the diagram
show, it means you have finished the Router’s basic
To Next Page
Loading...
