(Press the button for about one second and WPS
indicator will be blinking for 2 minutes, which
means the WPS is enabled. During the blinking
time, you can enable another device to
implement the WPS/PBC negotiation between
them. Two minutes later, the WPS indicator will be
off, which means the WPS connection is
completed. If more clients are added, repeat the
above steps. At present, the WPS supports up to
32 clients access.)
PIN：If this option is enabled, you need to enter
a wireless client’s PIN code in the field and keep
the same code in the WPS client.
WPS Summary： Show the current state of Wi-
Fi protected setting, including authorized mode,
encryption type, default key and other
information.
WPS Current Status ： Idle means WPS in idle
state. Start MSC process means the process has
been started and waits for being connected.
Configured means the negotiation is successful
between server and clients.
WPS Configured： “yes” means WPS feature is
enabled and goes into effect. “not used” means it
is not used. Usually the AP-security has been
enabled, here will displayed “not used”.
WPS SSID： Show the main SSID set by WPS.
WPS Auth. Mode ： The authorization mode
deployed by WPS, generally WPA/WPA2-personal
To Next Page
Loading...
