Tenda G3

Device Management
- 56 -
Parameter description in the page:
Parameter
Description
PPTP/L2TP Client
Enable or disable the PPTP/L2TP client function. After this function is enabled, the
router is used as a VPN client.
Type
Type of client that the router acts as, including PPTP Client and L2TP Client.
WAN
Select the current WAN port, i.e. the router port where the PPTP/L2TP client is
enabled.
Server IP/Domain
Name
Enter a VPN server IP address/domain name to be connected to,which is generally a
WAN port IP address of the remote VPN router as a server where the "PPTP/L2TP
Server" function is enabled.
Username/password
Enter a username/password assigned to the PPTP/L2TP client by the VPN server.
Encryption
Whether to enable data encryption. Server settings shall be consistent with client
settings.
VPN Proxy
When this function is enabled after a VPN rule is established, the client router can
surf the Internet through the server router.
Remote LAN
LAN segment under the VPN server.
Remote subnet mask
Subnet mask of LAN under the VPN server.
Status
Display the connection status of the current VPN client.
4.5.2 PPTP/L2TP Server
The PPTP/L2TP server allows specified users to dial into the server. For example, simple and safe access between
the branch and the headquarters is required. This can be achieved by using the VPN server function in the router
in the headquarters and the VPN client function in the router in the branch.
Click 『VPN』>『PPTP/L2TP Server』 to go to the configuration page.