Tenda G3

Device Management
- 73 -
After an "IP-MAC Binding" rule is added, the page is shown in the figure below.
Parameter description in the page:
Parameter
Description
IP-MAC Binding
Enable/Disable the IP-MAC binding function. The default is Disable.
Binding List
Click this button to manually add bound IP and MAC addresses.
Click this button to unbind a selected bound rule.
IP Address
Displays a bound IP address.
MAC
Address
Displays a MAC address corresponding to a bound IP address.
Remark
Displays the description of a corresponding rule. No remark information is
displayed if it is not set during dynamic or manual binding.
Action
Perform the edit or delete action on a bound rule.