Tenda HD series - System Settings (SD Series); User, Time, and PTZ Settings; Factory Reset, Reboot, and UI Upgrade

www.tenda.cn
5.7. System settings
5.7.1. User setting
5.7.2. Device date and time settings
You can enable “Sync with NTP Server” when the device was connected to WAN, but need
to select correct time zone where the camera is located, otherwise need to select“ Sync with PC
time”.
5.7.3. PTZ settings
It will stop cruise automatically after cruising an hour when you select cruise turns as
“always”.
5.7.4. Restore factory setting
Click “Restore factory setting” and confirm, the camera will restore to factory setting and
reboot.
5.7.5. Reboot device
You can reboot the device.
5.7.6. Upgrade Web UI
There are two kinds of firmware run in the camera, one is system firmware, another one is
Web UI, you can upgrade them respectively.