Port Management
- 23 -
3.4 Rate Limit
Here you can set the Tx Rate and Rx Rate of Downlink Ports.
Click Port Management > Rate Limit to enter the page below.
Buttons:
Clear all sets of Rate Limit. All ports receive and transmit the data frame in
an actual link speed.
Set the data transmitting rate of the selected port.
Set the data receiving rate of the selected port.
Check the box at the front of the corresponding port number to select
that port. Check the box at the top to select all of the ports.
Parameter specification of the display list：
Check the box at the front of the corresponding port number to set the
rate limit.
The rate limit is only available for the downlink ports, not available for the
uplink ports (G1/SFP1, G2/SFP2).
Display the transmitting rate limit of the port. “--” shows that the port will
To Next Page
Loading...
