VLAN Management
- 41 -
Tip
The VLAN deleted will be displayed in the “Available VLANs”, and the VLAN added will be
displayed in the “Member VLANs”.
4. Click OK to end the setup. The outcome is shown in the page below.
Restore VLAN Port Configuration to the State of Factory default settings
This function is available when port VLAN is intended to be restored to the state of factory
default settings with other configurations remained the same.
Configuration Steps:
1. Log in the Web administration and go to VLAN Management > Port VLAN page;
2. Click Default
Upon completion, port VLAN will be restored to the factory settings, i.e. all ports are in the
VLAN1.
To Next Page
Loading...
