VLAN Management
- 47 -
7.4.2.2 VLAN Division
This part takes the form of example to describe how to add, delete and modify 802.1Q
VLAN.
Add 802.1Q VLAN
Suppose to add the port 2, 3 to VLAN2.
Configuration Steps:
1. Log in the Web administration and go to VLAN Management > 802.1Q VLAN page;
2. Select: Check the before Port No. and select the port to be set;
3. VLAN List: In the following input box, enter the VLAN ID of the port selected in the Step 2
Tip
Check the at the top to select all of ports.
The port can fall into several VLANs, but only one VLAN is permitted to be added.
4. Click +Add to end the setup. The outcome is shown in the page below.
To Next Page
Loading...
