Device Management
- 58 -
3. Enter the user device MAC address "FC4DD4F871CF" in the Static MAC Address 1
column;
4. Click the Binding drop-down menu and select Enable;
5. Click OK to end the setup. The outcome is shown in the page below.
Setting Verification
After the settings are finished, only the device with MAC address "FC:4D:D4:F8:71:CF"
among all user devices connected to Port 3 can access the higher-level network. If the
device with MAC address "FC:4D:D4:F8:71:CF" is connected to other ports of the switch,
this device cannot access the higher-level network.
8.1.3.1 Cancel MAC Binding
Networking Requirements
Cancel MAC address binding of Port 3 added in the above-mentioned example.
Configuration procedures
1. Log in to the web browser-accessible administrator page of the switch and go to the
To Next Page
Loading...
