Device Management
- 61 -
QoS Setting Procedure:
1. QoS Mode Selection: Select a QoS mode. If WRR is selected, you must also set Low
weight and High weight. Note that the proportion of High must be greater than that of Low.
This series of switches support a proportion of 1-7.
2. Click OK to finish QoS mode selection;
3. Click Port Management > Port Configuration and select a port (Assume that you select
Port 9 in this example). Set its "Priority" to "High", and the corresponding port will be in the
high-priority queue.
To Next Page
Loading...
