Device Management
- 70 -
Parameter specification:
Enable/Disable the loopback detection function.
After the function is enabled, if the port receives a BPDU message
forwarded by the port, the downstream equipment is considered as
giving rise to a loop, and the port is also set to Discard status.
Enable/Disable the auto-wakeup function.
Enable: When the wake-up time interval expires, the Discard port
enters into its Forwarding status and conducts detection over again.
Disable: When the port enters into its Discard status, the port
requires manual turn-on.
Set the wakeup time interval.
If the auto-wakeup is enabled, the Discard port enters into its Forwarding
status and conducts detection over again when the wake-up time interval
expires.
Specify Root Bridge
View the current root bridge status.
Parameter specification:
Display the bridge ID of current switch, and comprise the system priority
and MAC address of the switch.
In the entire network spanning tree, it is selected to serve as a bridge ID
of root bridge device.
To Next Page
Loading...
Need help?
General
