Device Management
- 83 -
II. Configure the SNMP administrator
On the SNMP management software of SNMP v1 /v2c version, set the “Read only
community string” and “Read & Write community string”, and notice that they shall be kept
in line with the switch configuration. Refer to the manual supporting SNMP management
software for specific methods.
Verify the configuration
When the above-mentioned setting is finished, SNMP administrator can establish SNMP
connection with the SNMP agent on the switch, and inquire and set the values of some
parameters through the MIB nodes.
If a fault or error occurs on the switch, SNMP administrator can see corresponding warning
message.
To Next Page
Loading...
