ADSL2/2+ Router
Filter Mode: Select Deny or Allow according to your own needs.
Select: Select a number (indicating a filter rule) from the
drop-down menu.
Description: Enter a meaningful name to yourself for a new filter
rule.
Start /End IP Address: Enter a starting/ending IP address.
Port: Enter TCP/UDP protocol port number (s); it can be a range
of ports or a single port.
Traffic Type: Select a protocol or protocols for the traffic
(TCP/UDP/Both).
Time: Select a time range for the rule to take effect.
Day: Select a day or several days for the rule to take effect.
Enable: Check to enable or uncheck to disable a corresponding
filter rule （ allow/disallow matched packets to pass through
router）.
Example 1: To prohibit PCs within the IP address range of
192.168.1.100--192.168.1.150 from accessing Internet, do as follows:
- 78 -
To Next Page
Loading...
