300M Wireless-N Access Point
Chapter 2 Hardware Installation
This chapter explains how to connect the Access Point
(take the AP mode installation as example, other
installation modes please refer to the Quick
Installation Guide). The detailed processes are shown
as below:
1. Connect one end of the network cable to your
Ethernet broadband router, switch or PC, and the
other end to the W300A’s LAN port.
2. Connect the power adapter to the AP’s Power jack.
Then plug the power adapter into an electrical
outlet. The power LEDs on the front panel will light
up as soon as the AP’s powers on. Then, connect
wireless adapter to the AP via wireless signals.
Please refer to the topology below:
8
To Next Page
Loading...
