300M Wireless-N Access Point
4.1.4 Wireless Repeater Mode
Repeater Mode can repeat and amplify wireless signals
to extend wireless network coverage. In this mode,
wireless clients are allowed to connect.
4.1.4.1 Application and Topology Plan
When two LAN’s transmission distance is over the
wireless device’s maximum transmission value, or
there is much block among devices, you can use the
Repeater mode to deal with these problems by adding
MAC addresses. The topology shows below:
4.1.4.2 Repeater Mode Setting
In the working mode, select “AP Repeater” to enter the
next window.
43
To Next Page
Loading...
