300M Wireless-N Access Point
characters with 8-63 ASCII characters.
AES Encryption Description
Pass Phrase
：
Enter the encrypted
characters with 8-63 ASCII characters.
AP MAC Address
：
Input the MAC addresses
(no more than four) of remote access points
by manual or scan.
MAC Address 1
：
Input AP1’s MAC address;
MAC Address 2
：
Input AP2’s MAC address;
MAC Address 3
：
Input AP3’s MAC address;
MAC Address 4
：
Input AP4’s MAC address;
Open Scan
：
Enable scan to obtain remote
AP MAC address, select one and Click “Save”
to complete this part’s setting. The AP will
reboot automatically, the setting will go into
effect.
Note: In this mode, the two devices should
keep the same channel and encryption
method.
42
To Next Page
Loading...
